Conettix D6600 Installation Guide download pdf (Page 5)

D6600 | System Guide | 2.0 Overview

Bosch Security Systems, Inc. | 4/10 | 4998122712-04 5

Figure 3: System Connection Diagram using

C900V2 or C900TTL-E and Any

Alarm Panel

123 456 78910

PANEL

TELCO

1 - Any manufacturer’s control panel

2 - Connection – Control panel to

C900V2/C900TTL-E Ethernet jack

3 - C900V2 or C900TTL-E

4 - Connection – C900V2/C900TTL-E Ethernet

jack to Ethernet hub

5 - Host PC- 6200 Programming Administrative

Software

6 - Connection - Host PC Ethernet NIC to

Ethernet hub

7 - Ethernet hub

8 - Connection - Ethernet hub to D6100i

9 - D6100i

10 - Connection - Ethernet hub to D6680/D6682

11 - D6680/D6682

12 - Connection - D6680/D6682 to D6600 COM1

(optional)

13 - D6600

14 - Connection - D6680/D6682 to D6600 COM4

15 - Connection - Ethernet hub to D6680/D6682

The other type of network interface for alarm panels is

the D9133TTL-E, DX4020, or ITS-DX4020-G Network

Interface. These modules are designed for use with

Bosch control panels only. These modules and the

Bosch control panels communicate using the control

panel bus rather than the dialer capture method used

by the C900V2/C900TTL-E.

Figure 4 is a diagram of a Conettix D6600/D6100i

System using Bosch control panels: D9133TTL-E,

DX4020, or ITS-DX4020-G, D6600, D6100i, and

D6680/D6682.

Figure 4: System Connection Diagram using

Network Modules and Bosch

Control Panels

1248

1 - Bosch control panel

2 – Connection – Control panel bus to

D9133TTL-E /DX4020/ ITS-DX4020-G bus

3 - D9133TTL-E, DX4020, or ITS-DX4020-G

4 - Connection – D9133TTL-E/ DX4020/

ITS-DX4020-G Ethernet jack to Ethernet hub

5 - Host PC- 6200 Programming Administrative

Software

6 - Connection – Ethernet hub to host PC

Ethernet NIC

7 - Ethernet hub

8 - Connection – Ethernet hub to D6100i

9 - D6100i

10 - Connection - Ethernet hub to D6680/D6682

11 - D6680/D6682

12 - Connection - D6680/D6682 to D6600 COM1

(optional)

13 - D6600

14 - Connection - D6680/D6682 to D6600 COM4

15 - Connection - Ethernet hub to D6680/D6682

The D6200 Programming/Administration Software is a

D6600/D6100i programming utility that works over a

network connection. Each network interface device

(D6680/D6682, D9133TTL-E/DX4020/ITS-DX4020-G,

or C900V2/C900TTL-E) must be added to the

Address Resolution Protocol (ARP) and is used to

temporarily associate an IP address with a hardware

address table, then configured through a telnet

session before network communications will function.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Conettix D6600 Installation Guide Page 5

Comments to this Manuals

Related products and manuals for Gateways/controllers Conettix D6600