Conettix D6600 Installation Guide download pdf (Page 16)

D6600 | System Guide | 5.0 D6100i Configuration Setup Instructions

16 Bosch Security Systems, Inc. | 4/10 | 4998122712-04

This command displays the IP address 172.17.10.70

temporarily linked to MAC address

00-20-4a-12-04-0e as shown in

Figure 8. The

temporary link shows a static entry.

Figure 8: ARP Table

The network uses this table to identify devices and to

route signals. The number of devices and other types

(static and dynamic, as shown in the example)

depends on the network and the number and type of

devices with which this PC communicates. Identify the

MAC address of the device you are installing and

verify that it now has an IP address linked to it.

5.4 Using Telnet to Finish the

Configuration

To use Telnet, you must log in as a user

with Administrative privileges.

In Windows Vista, Telnet is disabled by

default. In order to use Telnet, you must

enable it:

1. Click Start→Control

Panel→Programs.

2. Click Turn Windows features on

or off.

If you are prompted for an

administrator password or

confirmation, type the password or

provide confirmation.

3. In the Windows Features dialog

box, select the Telnet Client check

box.

4. Click OK.

The installation might take several

minutes.

The MAC address, IP address, gateway

IP address, and port number in this

procedure are examples and are not the

same as those for your C900V2.

By default, Windows Vista does not

install the Telnet client. The Telnet client

is for text-based communication with

remote systems.

To install the Telnet client on a PC

running Windows Vista:

1. Click Start→Control Panel.

2. Select Programs and

Features.

3. Select Turn Windows features

on or off.

4. Select the Telnet Client option.

5. Click OK.

A dialog box opens to confirm

installation. The telnet command

is now available.

1. Select Start Æ Run.

The Run dialog box appears.

2. In the Run dialog box, type telnet and click OK.

The Telnet window appears.

3. Type open <IP ADDRESS> 1 and press [ENTER]

(where <IP ADDRESS> is the IP address of the

D6100i). Type a space after open and after the IP

address. For example:

open 172.17.10.70 1.

The connection fails the first time. This is normal.

4. Repeat Step

3 using 9999 as the port number.

5. Type open <IP ADDRESS> 9999 and press

[ENTER] (for example, open 172.17.10.70 9999).

6. Press [ENTER]. The Setup Mode information

appears.

Continue with Section

5.4.1 on page 16.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Conettix D6600 Installation Guide Page 16

Comments to this Manuals

Related products and manuals for Gateways/controllers Conettix D6600